[seqfan] Re: Mathematica code for A050446.

Ed Jeffery lejeffery7 at gmail.com
Tue Dec 20 05:19:41 CET 2011


Thanks to Harvey Dale, Chris Gribble, Richard Mathar and Alonso Del Arte
for comments regarding the Mathematica code in A050446.

I really didn't doubt the correctness of the code, however, setting up an
equation in Mathcad based on that code didn't produce the correct table.
But finally after a couple of tricks I was able to get it to work. If
anyone else out there uses Mathcad, please try producing the table as I did
using the Mathematica definitions and you should encounter the same
difficulties.

Thanks again,

Ed Jeffery



More information about the SeqFan mailing list