[seqfan] Re: Save failed

Neil Sloane njasloane at gmail.com
Sat Jan 27 03:59:44 CET 2018

Probably easier to edit on a computer!  But good to hear all is well now.

Best regards

Neil J. A. Sloane, President, OEIS Foundation.
11 South Adelaide Avenue, Highland Park, NJ 08904, USA.
Also Visiting Scientist, Math. Dept., Rutgers University, Piscataway, NJ.
Phone: 732 828 6098; home page: http://NeilSloane.com
Email: njasloane at gmail.com

On Fri, Jan 26, 2018 at 10:05 AM, jnthn stdhr <jstdhr at gmail.com> wrote:

> Neil,
> Before recycling I decided to tried editing again and saving, and all
> *appears* fine now.  I think the problem arose from a failure to enter an
> offset.  After saving my second edit I noticed a not too obvious (on my
> teeny tiny phone screen, at least) system complaint "malformed offset"
> (i.e. '~').
> It looks like if one navigates away with the edit in this state the result
> is the odd behavior observed.
> Jonathan
> --
> Seqfan Mailing list - http://list.seqfan.eu/

More information about the SeqFan mailing list